Removal & Installation: Window: Removal
- Lower the glass to the bottom of the door.
- Remove trim panel. See TRIM PANEL .
- Remove vent/window run channel assembly. See VENT/WINDOW CHANNEL ASSEMBLY
.NOTE: Mask or cover any sharp edges that could scratch the glass.
- Remove door window glass (230). See Figure . Slide the glass forward until the front roller is in line with the notch in the sash channel. Disengage the roller from the channel. Push the window forward, then tilt it up until the rear roller is disengaged. Place the window in a level position, and raise it straight up, and out of the door.