TDC Offset Program Procedure

This procedure allows the PCM memory to be updated with the correct TDC offset for the vehicle.

DTC 88 will be stored until this procedure has been completed Set up:

• Battery is fully charged.
• Engine operating at idle.
• Vehicle at operating temperature.
• Connect Tech 1 Scan Tool
• Select "OUTPUT TESTS" and "INJ. PUMP"
• Activate "TDC LEARN"
  NOTE: It takes PCM 20 seconds to learn TDC offset.
• Verify "TDC OFFSET" in data list.
• DTC 88 will be stored if procedure has not been done correctly.
  NOTE: If the PCM fails to program the TDC OFFSET, do the following:
• Check all PCM connections.
• Check Techline terminal/equipment for latest software version.
• Try again to program the PCM. If it fails again replace the PCM.