LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 1998 >> Forward Control 6.5 F >> Repair and Diagnosis >> General Information >> Computer Relearn Procedures >> Computer Relearn Procedures >> "P" Body >> Electronically Erasable Programmable Read Only Memory (EEPROM) Programming (4.3L & 5.7L)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Electronically Erasable Programmable Read Only Memory (EEPROM) Programming (4.3L & 5.7L)

  1. If Vehicle Control Module (VCM) was replaced, the EEPROM in the VCM must be programmed. If EEPROM is not programmed, a Diagnostic Trouble Code (DTC) will be set in the VCM.
  2. Ensure battery is fully charged. Ensure cable is properly connected on Data Link Connector (DLC). Turn ignition on. Perform EEPROM programming using the Techline equipment manufacturer's instructions and latest software applicable for the vehicle model.
    NOTE: If EEPROM programming fails, ensure all electrical connections on VCM are okay. Check Techline for latest software. If EEPROM programming still fails, replace VCM.
  3. Once EEPROM has been reprogrammed, Crankshaft Position (CKP) sensor variation learn procedure must be performed using proper procedure. Once Crankshaft Position (CKP) sensor variation learn procedure has been performed, perform powertrain On-Board Diagnostic (OBD) system check. See POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK in appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
scientia non olet · About LEMON Manuals