Engine Controls - System & Component Testing: Introduction

Before testing separate components or systems, follow proper workflow. See TESTING PROCEDURE under SELF-DIAGNOSTIC SYSTEM in appropriate SELF-DIAGNOSTICS article. If no Diagnostic Trouble Codes (DTCs) are present and a no-start condition exists, proceed to BASIC DIAGNOSTIC PROCEDURES - TRUCKS - EXCEPT TRACKER article. If no DTCs are present and a driveability condition exists, proceed to TROUBLE SHOOTING - NO CODES - TRUCKS article for diagnosis by symptom (i.e., ROUGH IDLE, ENGINE STALLS, etc.).

NOTE: Testing individual components does not isolate shorts or opens. Perform all voltage tests with a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure. Use ohmmeter to isolate wiring harness shorts or opens.