LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2005 >> Jimmy Automatic, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - (Introduction) >> Repair Instructions >> Distributor Overhaul >> Assembly Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Assembly Procedure

    Fig 1: View Of Square-Cut Hole In Vane Wheel
    GM156754Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Distributor Driven Gear Can Be Installed in Multiple Positions Notice in Cautions and Notices.
  1. Line up the square-cut hole in the vane wheel for the CMP sensor.
    2. Fig 2: View Of CMP Sensor
    GM156755Courtesy of GENERAL MOTORS CORP.
  2. Insert the sensor into the housing.
    3. Fig 3: View Of CMP Sensor & Screws
    GM301398Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install two new screws for the camshaft position (CMP) sensor.

    Tighten:  Tighten the screws to 2.2 N.m (19 lb in).

    4. Fig 4: View Of Rotor Screw Holes & Locator Pin Holes
    GM156752Courtesy of GENERAL MOTORS CORP.
  4. Identify the correct rotor mounting position:
    • At the rotor screw holes (1)
    • At the rotor locator pin holes (2)
    5. Fig 5: View Of Distributor Cap Rotor
    GM301396Courtesy of GENERAL MOTORS CORP.
  5. Install the distributor rotor according to the index marks.
  6. Install two rotor hold down screws.

    Tighten:  Tighten the screws to 1.9 N.m (17 lb in).

    7. Fig 6: View Of Distributor Shaft Shim Washer
    GM301405Courtesy of GENERAL MOTORS CORP.
  7. Install the shim washer (1) on the bottom of the distributor shaft.
  8. Install the tang washer.
  9. Install the round washer.
  10. Install the driven gear according to the index marks.
    11. Fig 7: View Of Gear Pre-drilled Indent Hole & Rotor Segment
    GM301395Courtesy of GENERAL MOTORS CORP.
  11. Align the rotor segment as shown for a V6 engine (1) or V8 engine (2).
  12. Install the gear and align white paint mark on the bottom stem of the distributor, and the pre-drilled indent hole in the bottom of the gear (3).
  13. Check to see If the driven gear is installed incorrectly, the dimple will be approximately 180 degrees opposite the rotor segment when the driven gear is installed in the distributor.
    14. Fig 8: Driving Out/In Roll Pin
    GM301198Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.
  14. Support the distributor drive gear in a V-block or similar fixture.
  15. Install the roll pin with a suitable punch and hammer in order to hold the driven gear in the correct position.
    16. Fig 9: View Of Distributor Shaft Oil Seal
    GM301419Courtesy of GENERAL MOTORS CORP.
  16. Install the new oil seal under the mounting flange of the distributor base.
  17. Install the distributor.
scientia non olet · About LEMON Manuals