LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2005 >> Jimmy Automatic, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - (Introduction) >> Repair Instructions >> Powertrain Control Module (PCM) Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Remove the replacement PCM from the packaging.
  2. Verify the service number in order to ensure the service number is the same number as the faulty PCM.
    3. Fig 1: View Of PCM Electrical Connectors
    GM66513Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Connect the PCM electrical connectors.

    Tighten:  Tighten the PCM electrical connectors screws to 8 N.m (71 lb in).

    4. Fig 2: View Of PCM
    GM352489Courtesy of GENERAL MOTORS CORP.
  4. Slide the PCM retainer into the PCM bracket slots.
    5. Fig 3: View Of PCM Retention Bar & Retainer
    GM352488Courtesy of GENERAL MOTORS CORP.
  5. Pull the PCM retention bar into position.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  7. Program the PCM. Refer to Control Module References in Computing/Integrating Systems.
scientia non olet · About LEMON Manuals