LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2005 >> Jimmy Part Time, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - (Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: View Of Ignition Coil Wire At Distributor
    GM302854Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the spark plug wires and ignition coil wire from the distributor. Refer to Spark Plug Wire Replacement .
    2. Fig 2: Identifying Camshaft Position (CMP) Sensor Harness Connector
    GM302829Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the camshaft position (CMP) sensor harness connector from the distributor.
    3. Fig 3: View Of Distributor Cap Screws
    GM157984Courtesy of GENERAL MOTORS CORP.
  3. Remove the distributor cap screws.
    4. Fig 4: View Of Distributor Cap
    GM157986Courtesy of GENERAL MOTORS CORP.
  4. Remove the distributor cap.
    5. Fig 5: View Of Rotor Screws
    GM4354Courtesy of GENERAL MOTORS CORP.
  5. Remove the rotor screws.
    6. Fig 6: View Of Rotor
    GM156748Courtesy of GENERAL MOTORS CORP.
  6. Remove the rotor.
    7. Fig 7: View Of Square-Cut Hole In Vane Wheel
    GM156754Courtesy of GENERAL MOTORS CORP.
  7. Align the square slot in the reluctor wheel with the CMP sensor.
    8. Fig 8: View Of CMP Screws
    GM4341Courtesy of GENERAL MOTORS CORP.
  8. Remove the CMP screws.
    9. Fig 9: View Of CMP Sensor & Screws
    GM301398Courtesy of GENERAL MOTORS CORP.
  9. Remove the CMP sensor.
scientia non olet · About LEMON Manuals