Removal Procedure
- Disconnect the negative battery cable.
- Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .
- Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Resonator Replacement .
- Disconnect the spark plug wires from the left side of the distributor.
- Disconnect the chassis fuel feed and return pipes (1) at the engine compartment fuel feed and return pipes.
- Remove the injector fuel inlet and outlet pipe retainer nuts.
- Remove the injector fuel inlet and the outlet pipe retainer.
- Remove the rear fuel pipe bracket retaining bolt.
- Pull straight up on the fuel pipes in order to remove the fuel pipes from the injector assembly.
- Remove the O-ring seals from both ends of the fuel feed and return pipes.
- Discard the O-ring seals.
CAUTION:
Refer to Battery Disconnect Caution in Cautions and Notices.