Removal Procedure
IMPORTANT:
An 8 digit part identification number is stamped on the bottom of the throttle body casting. Refer to this number if servicing or part replacement is required.
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
- Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Resonator Replacement .
- Remove the air cleaner adapter stud.
- Disconnect the cruise control cable from the throttle body. Refer to Cruise Control Cable Replacement (LU3) in Cruise Control.
- Disconnect the accelerator cable from the throttle body. Refer to Accelerator Controls Cable Replacement .
- Remove the nuts retaining the accelerator cable routing bracket.
- Position the bracket aside.
- Remove the stud and nuts retaining the accelerator control cable bracket.
- Position the bracket aside.
- Disconnect the idle air control (IAC) valve harness connector.
- Disconnect the throttle position (TP) sensor harness connector.
- Remove the throttle body retaining studs.
- Remove the throttle body assembly.
- Discard the throttle body seal.