Unsuccessful Programming Recovery

If programming a control module is not successful, perform the following procedure:

1. Verify the control module, data link connector and programming tool connections are secure and the SPS software is up to date.
2. Ignition » On / Vehicle » In Service Mode
3. Access SPS and follow the on-screen instructions for the control module:Q8 Control Solenoid Valve Assembly or K71 Transmission Control Module

   Verify the control module programming is successful.

   • If the programming is not successful 
   1. Ignition/Vehicle » Off - For greater than 1 min
   2. Ignition » On / Vehicle » In Service Mode
   3. Access SPS and follow the on-screen instructions for the control module:Q8 Control Solenoid Valve Assembly or K71 Transmission Control Module
      • If the programming is not successful » Replace the component: Q8 Control Solenoid Valve Assembly
      • If the programming is successful
   4. Perform the following learn procedure:Transmission Adaptive Values Learn
   5. All OK.
   • If the programming is successful 
4. Perform the following learn procedure:Transmission Adaptive Values Learn
5. All OK.