Reprogram Control Module

To reprogram an existing control module, perform the following procedure:

1. Install EL-49642  SPS Programming Support Tool.
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select K47 Rear Differential Clutch Control Module - Programming and follow the on-screen instructions.
4. On the SPS Supported Controllers screen, select K47 Rear Differential Clutch Control Module - Setup and follow the on-screen instructions.
   NOTE:

   RPO G99 = Twin Clutch System

5. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.