Reprogram Steering Column Lock Control Module
NOTE:
Before reprogramming, to ensure that the steering column lock password from the BCM is learned: turn ignition ON and then OFF, close all doors, and wait 5 minutes.
To reprogram an existing steering column lock control module, perform the following procedure:
- Ignition ON for 10 seconds, ignition OFF.
- Close all doors and wait 5 minutes.
- Ignition ON.
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K60 Steering Column Lock Control Module - Programming and follow the on-screen instructions.
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.