Replace and Program Control Module or Reprogram Control Module
WARNING: This page is about a different car, the 2020 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
To program a replacement or an existing control module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K40D Seat Memory Control Module - Driver - Programming and follow the on-screen instructions.
- Clear DTCs.
- Move the seat to a central, middle range position, then perform the memory store operation for memory "1", "2", and "Exit" or "3" if equipped. Refer to the Owner Manual for storing memory seat positions.