April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fastener Specifications

Single Use Non-Threaded Fasteners/Components

NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
Application
Power Steering Assist Motor Seal
Steering Gear Belt
Steering Gear Boot Inner Clamp

Single Use Threaded Fastener/Component Tightening Specifications

NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
Application	Specification
Application	Metric (English)
Power Steering Assist Motor Pivot Bolt	10 N.m (89 lb in)
Steering Gear Housing Bolt	25 N.m (18 lb ft)

Reusable Threaded Fastener Tightening Specifications

NOTE: All fasteners listed in this table can be reused after removal.
Application	Specification
Application	Metric (English)
Steering Gear Bolt (Horizontal)
First Pass:	100 N.m (74 lb ft)
Final Pass:	45 - 60 degrees
Steering Gear Bolt (Vertical)	100 N.m (74 lb ft)
Steering Gear Heat Shield Bolt	10 N.m (89 lb in)
Steering Linkage Inner Tie Rod	100 N.m (74 lb ft)
Steering Linkage Outer Tie Rod Nut
First Pass:	35 N.m (26 lb ft)
Final Pass:	90 - 100 degrees