Adding Transmitters (Without SPS)

NOTE:

To initiate, this procedure requires that 2 learned transmitters be available.
A total of eight transmitters can be learned to a single vehicle.
This procedure adds transmitters only. The procedure does not erase previously learned transmitters.

Place both of the recognized transmitters in the vehicle cupholder.
Insert the vehicle key into the key cylinder on the driver door handle and turn the key, counterclockwise, to the unlock position five times within ten seconds. The driver information center will display Ready For Remote #2, 3, 4 or 5.

NOTE:

The transmitter pocket can be found in the following locations:

Place the new transmitter into the transmitter pocket.
Press and release the ignition mode switch. When the transmitter is learned, the driver information center will indicate that it is ready to program the next transmitter.
Remove the transmitter from the transmitter pocket and press the transmitter unlock button. To program additional transmitters, repeat Steps 3 through 5.
When all additional transmitters are programmed, press and hold the ignition mode switch for 15 seconds to exit programming mode.