April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fastener Specifications

Single Use Non-Threaded Fasteners/Components

NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
Application
Power Steering Assist Motor Seal
Steering Gear Boot Inner Clamp

Single Use Threaded Fastener/Component Tightening Specifications

NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
Application	Specification
Application	Metric (English)
Power Steering Assist Motor Bolt	21 N.m (15 lb-ft)

Reusable Threaded Fastener Tightening Specifications

NOTE: All fasteners listed in this table can be reused after removal.
Application	Specification
Application	Metric (English)
Steering Gear Bolt
First Pass:	100 N.m (74 lb-ft)
Final Pass:	45 - 60 degrees
Steering Gear Heat Shield Bolt	9 N.m (80 lb/in)
Steering Linkage Inner Tie Rod	105 N.m (77 lb-ft)
Steering Linkage Outer Tie Rod Nut
First Pass:	35 N.m (26 lb-ft)
Final Pass:	80 - 90 degrees