Replace and Program Control Module

To program a replacement control module, perform the following procedure:

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
2. On the SPS Supported Controllers screen, select K17 Electronic Brake Control Module - Programming and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select K17 Electronic Brake Control Module - Setup and Configuration follow the on-screen instructions.
4. Clear DTCs
5. With a scan tool, perform the Electronic Brake Control Module-Control Functions Automated Brake Bleed following the scan tool instructions. Refer to Antilock Brake System Automated Bleed .