Cruise Control Module: Remove & Replace
WARNING: This page is about the Yukon Denali, 3.0L Eng VIN T, 4WD, which is a different variant/trim than selected.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| ABS Control Unit,w/Adaptive Cruise Control | Includes: Programming. Includes: R&I Fender Liner. | 1.8 | 1.3 | B |
| Body Control Module | Includes: Programming. | 1.1 | 0.9 | B |
| Distance Sensing Cruise Control,Radar Unit | Includes: Programming. Includes: Calibration. Includes: R&I Front Bumper Cover. | 2.7 | B | |
| Engine Control Module | Includes: Programming. Includes: Reset Oil Life Monitor. | 1.5 | B | |
| Image Processing Module,w/Adaptive Cruise Control,w/o Third Row Seating | Includes: Programming. Includes: Calibration. Includes: R&I Quarter Trim. | 2.9 | 1.1 | B |
| Image Processing Module,w/Adaptive Cruise Control,w/Third Row Seating | Includes: Programming. Includes: Calibration. Includes: R&I Rear Seat Assembly. Includes: R&I Quarter Trim. | 3.3 | 1.1 | B |
| Transmission Control Module,w/Adaptive Cruise Control | Includes: Programming. | 1.2 | 0.7 | B |
| Combination Procedure: BAROMETRIC SENSOR: Reset: | ||||
| 3.0L Eng | Includes: Additional time for use of scan tool to perform this procedure. | 0.2 | B | |
| Combination Procedure: FUEL INJECTION SYSTEM: Reset: | ||||
| 3.0L Eng, Fuel Injector Flow Rate Programming | Includes: Additional time for use of scan tool to perform this procedure. | 0.2 | B | |
| Combination Procedure: REDUCTANT FLUID SYSTEM: Reset: | ||||
| 3.0L Eng, Exhaust Aftertreatment System Learned Values | Includes: Additional time for use of scan tool to perform this procedure. | 0.2 | C | |
| Combination Procedure: TURBOCHARGER BOOST PRESSURE: Reset: | ||||
| 3.0L Eng, Turbocharger Boost Control Initial Position Learn | Includes: Additional time for use of scan tool to perform this procedure. | 0.2 | B | |
| Combination Procedure: VEHICLE DYNAMIC SENSOR: Calibrate: | ||||
| w/Adaptive Cruise Control,Vehicle Dynamic Sensor Offset Calibration | Includes: Additional time for use of scan tool to perform this procedure. | 0.2 | B | |