Transmission Assembly: Remove, Install, and Overhaul
WARNING: This page is about the Yukon Denali, 3.0L Eng VIN T, 4WD, which is a different variant/trim than selected.
Includes: Inspect and replace all necessary components, clean and check Converter, flush Oil Cooler Lines, adjust and road test.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 3.0L Eng,4WD, w/Air Suspension | Includes: Transmission Programming and Calibration of Learned Parameters. Includes: R&I Fender Liner. Includes: R&I Catalytic Converter. Includes: R&I Starter Assembly. Includes: R&I Propeller Shaft. Includes: R&I Transmission Support. Includes: R&I Transfer Case Assembly. Includes: Drain and Refill Air Suspension System. Includes: Additional time for use of scan tool to perform this procedure. Includes: Check and adjust Transmission Fluid level with fluid temperature within parameters. | 20.9 | A | |
| 3.0L Eng,4WD, w/o Air Suspension | Includes: Transmission Programming and Calibration of Learned Parameters. Includes: R&I Fender Liner. Includes: R&I Catalytic Converter. Includes: R&I Starter Assembly. Includes: R&I Propeller Shaft. Includes: R&I Transmission Support. Includes: R&I Transfer Case Assembly. Includes: Check and adjust Transmission Fluid level with fluid temperature within parameters. | 20.5 | A | |
| Additional Procedure: TRANSMISSION ASSEMBLY: Remove, Install, and Overhaul: | ||||
| Where Skid Plate interferes add | 0.2 | A | ||
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace: | ||||
| 3.0L Eng, Rear,Timing Chain Lower Cover | Includes: Reset Oil Life Monitor. | 1.2 | B | |
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| 0.3 | C | |||
| Combination Procedure: TRANSFER CASE ASSEMBLY: Overhaul: | ||||
| 4WD | 4.3 | A | ||
| Combination Procedure: TRANSFER CASE ASSEMBLY: Replace: | ||||
| 4WD | Includes: Perform Relearn procedure. | 0.5 | C | |