LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2021 >> Yukon AT4 >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> K56 Serial Data Gateway Module: Programming and Setup >> Unsuccessful Programming Recovery
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Unsuccessful Programming Recovery

NOTE:

Ensure the EL-52100  is used when programming the vehicle.

In the event of an interrupted or unsuccessful programming event, perform the following steps:

  1. Verify the K56 Serial Data Gateway Module, X84 Data Link Connector, and programming tool connections are secure and the SPS software is up to date.
  2. Ignition/Vehicle OFF.
  3. Access SPS and follow the on-screen instructions for the K56 Serial Data Gateway Module.
  4. Verify the K56 Serial Data Gateway Module can be reprogrammed.
    • If the K56 Serial Data Gateway Module cannot be reprogrammed 
    1. Ignition/Vehicle OFF for greater than 1 min.
    2. Access SPS and follow the on-screen instructions for the K56 Serial Data Gateway Module.
    3. Verify the K56 Serial Data Gateway Module can be reprogrammed.
      • If the K56 Serial Data Gateway Module cannot be reprogrammed, replace the K56 Serial Data Gateway Module.
      • Go to next step: If the K56 Serial Data Gateway Module can be reprogrammed.
    4. All OK.
    • Go to next step: If the K56 Serial Data Gateway Module can be reprogrammed 
  5. All OK.
scientia non olet · About LEMON Manuals