Reprogram Control Module

To reprogram an existing K20 Engine Control Module, perform the following procedure:

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
2. Perform one of the following SPS Programming functions:
   NOTE:

   If both controller options below are listed, select K20/K71 Engine and Transmission Control Modules.

   • K20/K71 Engine and Transmission Control Modules and follow the on-screen instructions.
   • K20 Engine Control Module and follow on-screen instructions.
3. Clear DTCs after completing the Programming procedure.
4. If equipped, perform the Fuel Pressure Regulator Learn via GDS2, Engine Control Module, Configuration/Reset Functions, Learn Functions.
5. Clear DTCs.