LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2022 >> Acadia AT4 >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> K43 Power Steering Control Module: Programming and Setup >> Power Steering Control Module Reprogramming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Steering Control Module Reprogramming

Do not program or reprogram the electronic power steering control module unless directed by a service procedure or a service bulletin.

NOTE:

This procedure applies to reprogramming of the existing steering gear or the initial programming if the complete steering gear assembly including the assist motor was replaced. If only the power steering control module is replaced, follow the Power Steering Control Module Replacement instructions above.

  1. Access the Service Programming System (SPS) and follow the on-screen instructions.
  2. On the SPS Supported Controllers screen, select K43 Power Steering Control Module - Programming and follow the on-screen instructions.
  3. Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down.
  4. Ignition ON.
  5. On the SPS Supported Controllers screen, select K43 Power Steering Control Module - Setup and follow the on-screen instructions.
  6. Clear DTCs.
scientia non olet · About LEMON Manuals