Circuit/System Testing

Vehicle Off.
Disconnect the electrical connector: A110 Charge Port Housing
Connect a test lamp between the test points: Control circuit terminal X2-12 & Control circuit terminal X2-13
Vehicle On
Perform the scan tool control function: Battery Charger Coupler Lock - Open/Close
Verify the test lamp turns On.
- If the test lamp does not turn On
1. Vehicle Off. Remove - Test Lamp
2. Disconnect the electrical connector: K16A Battery Energy Control Module 1
3. Test for infinite resistance between the test points:
  - Control circuit terminal X2-13 @ Component harness & Ground
  - Control circuit terminal X2-12 @ Component harness & Ground
  - Control circuit terminal X2-13 @ Component harness & Control circuit terminal X2-12
  - If less than infinite resistance - Repair the short to ground on the circuit or Short between the circuits
  - Go to next step: If infinite resistance
4. Test for less than 2 ohms between the test points:
  - Control circuit terminal X2-13 @ Component harness & Terminal X2-18 @ Control module harness
  - Control circuit terminal X2-12 @ Component harness & Terminal X2-17 @ Control module harness
  - If 2 ohms or greater - Repair the open/high resistance in the circuit.
  - If less than 2 ohms - Replace the component: K16A Battery Energy Control Module 1
- If the test lamp turns On
  Replace the component: X98 Battery Charger Coupler