Reprogram Control Module

To reprogram an existing K107 Drive Motor Control Module, perform the following procedure:

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
NOTE:

The K107 Drive Motor Control Module, K107B Drive Motor Control Module 2 and K107C Drive Motor Control Module 3 will be programmed together.

2. On the SPS Supported Controllers screen, select K107 - Drive Motor Control Module - Programming and follow the on-screen instructions.
3. Clear DTCs after completing the Programming procedure.
4. Perform the following SPS function:
   1. Setup - If applicable

      K107 Drive Motor Control Module and follow on-screen instructions.

5. Clear DTCs.