LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2022 >> Hummer EV >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> K124 Image Processing Module: Programming and Setup (with UKL) >> Replace and Program Image Processing Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Replace and Program Image Processing Module

NOTE:

Due to continuous improvements, the on screen selections may vary from instructions below.

To program a replacement K12 Image Processing Module, perform the following procedure:

  1. Ignition/Vehicle OFF
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select K124 Image Processing Module - Programming and follow the on-screen instructions.
  4. Perform the Vehicle Dynamic Sensor Offset Calibration. Refer to: Vehicle Dynamic Sensor Offset Calibration
  5. Clear DTCs.
scientia non olet · About LEMON Manuals