Replace and Program Control Module

To program a replacement control module, perform the following procedure:

1. Ignition/vehicle OFF
2. Connect a USB drive to the computer.
3. Perform a Quick Format on the USB drive to FAT32.
4. Access the Service Programming System (SPS) and follow the on-screen instructions.
5. On the SPS Supported Controllers screen, select A11 Radio - USB Copy/USB File Transfer.
NOTE:

If USB programming is unavailable, or if the selected software description is the following proceed to step 11: STOP. If you are seeing this text, the controller already has the latest software available. If you try to proceed further, SPS will generate an error.  .

6. Upon completion of the file transfer, properly eject the USB drive from the computer.
NOTE:
• The Radio screen will be blank because of not being programmed.
• For instructions on passive power moding, refer to Power Mode Description and Operation
7. Ignition ON, infotainment system ON.
8. On the SPS Supported Controllers screen, select A11 Radio - USB File Download Status and follow the on-screen instructions.
   NOTE:

   After installing the USB in the vehicle, do not remove until receiving the Complete message in SPS.

9. Connect the USB drive to the USB port in the vehicle. Programming may take up to 30 minutes.
10. Upon completion of programming, remove the USB drive and follow the on-screen instructions in SPS.
NOTE:
• If the radio displays "Recovery Mode. Please Calibrate Device." Proceed to step 11.
11. On the SPS Supported Controllers screen, select A11 Radio - Programming and then follow the on-screen instructions.
NOTE:

If the Radio displays "Theft Lock" repeat step 11.

12. On the SPS Supported Controllers screen, select A11 Radio - Setup and then follow the on-screen instructions.
13. Clear DTCs.
14. Ignition OFF, Retained Accessory Power (RAP) OFF, remove the key fob from range of the vehicle, and let the vehicle sit for five minutes. Retest system operation to verify the repair.