LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2023 >> Canyon AT4 >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> B218L Side Obstacle Detection Control Module - Left: Programming and Setup >> Replace and Program ECU or Reprogram ECU
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Replace and Program ECU or Reprogram ECU

To program a replacement or an existing ECU, perform the following procedure:

NOTE:
  • Due to continuous improvements, the on screen selections may vary from instructions below.
  • It is recommended to program both the left and right (if programmable) when a programming event is required.
  • Some systems only have one programmable Side Object Sensor Module.
  1. Ignition/Vehicle OFF
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select B218 Side Object Sensor Module then select B218R Right Side Object Sensor Module or B218L Left Side Object Detection.
  4. On the SPS Select Function / Sequence screen, select Sequential Programming or Programming
  5. Clear DTCs.
scientia non olet · About LEMON Manuals