Transmission Assembly: Remove, Install, and Overhaul
WARNING: This page is about the Canyon AT4, which is a different variant/trim than selected.
Includes: Inspect and replace all necessary components, clean and check Converter, flush Oil Cooler Lines, adjust and road test.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 2.7L Eng,Automatic Trans,4WD | Includes: Programming. Includes: R&I Transfer Case Assembly. Includes: Confirm Fluid temperature for level check. | 18.5 | A | |
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace: | ||||
| 2.7L Eng, Rear | 0.5 | B | ||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| 2.7L Eng | 0.3 | C | ||
| Combination Procedure: TRANSFER CASE ASSEMBLY: Overhaul: | ||||
| 4WD | 4.0 | A | ||
| Combination Procedure: TRANSFER CASE ASSEMBLY: Replace: | ||||
| 4WD | 0.3 | C | ||