Repair Procedures: Installation

1. Tighten the power trunk module & drive unit mounting bolts and nuts.

   Tightening torque: 

   6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

2. Install the push rod in the hinge ball joint.
3. Connect the control unit connectors.
4. Install the right trunk trim.
5. Check that the power trunk operates normally after connecting the negative (-) battery terminal.

Information 

1. Make sure that the connectors are plugged in properly.
2. Check that the power tailgate operates normally.

1. If the drive unit mounting bolt gets lost and it still remains inside the chassis, the rattling noise caused by the bolt may lead to customer complaints.
2. Do not operate the power trunk module with the power connected while the push rod is removed.
3. When changing the trunk module and drive unit, always perform the parameter saving process.
4. Reset the power trunk module whenever a job is performed with the battery removed.
5. Always check for normal operation when a power trunk module related part is changed.

When abnormal system operation is found, check the DTC Code and the connection of the wiring and cable.