Repair Procedures: Removal
WARNING:
- DON'T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.
- Turn the ignition switch OFF and disconnect the battery negative (-) cable.
- Remove the cowl top cover.
(Refer to COWL TOP COVER Body )
- Remove the noise barrier (A).
- Disconnect the camshaft position sensor connector (A).
- Remove the installation bolt (B), and then remove the sensor.
[Bank 1/Intake]
[Bank 1/Exhaust]
[Bank 2/Intake]
[Bank 2/Exhaust]