Repair Procedures: Removal
CAUTION:
- Put on gloves before removing/installing the drive unit.
- Do not install or carry a push rod, controller and wire harnesses by holding it with bare hands.
- Be careful when removing the push rod, the trunk may close.
- Disconnect the negative (-) battery terminal.
- Remove the left trunk trim after opening the trunk.
(Refer to Body - "TRUNK TRIM ")
- Separate the power trunk module push rod pin (A) and then remove the power trunk module connecting rod (B).
- Remove the power trunk module & drive unit (A) after disconnecting the connector, bolts and nuts.
- Remove the power trunk module (A) after loosening the mounting screws.