[Bank 1]
WARNING:
- DON'T remove the Camshaft Position Sensor while the Engine is running or right after Engine is turned OFF. In this case, the hot Engine Oil could lead or cause burns.
- Turn the Ignition Switch OFF and disconnect the battery negative (-) cable.
- Remove the Intake Hose.
(Refer to Engine Mechanical System - "INTAKE AND EXHAUST SYSTEM ")
- Disconnect the Camshaft Position Sensor Connector (A).
- Remove the installation bolt (B), and then vertically remove the sensor from the cylinder head.
[Bank 1/Intake]
[Bank 1/Exhaust]