Repair Procedures: Installation
- Combustion seal
- Rubber washer
- Support disc
- O-ring
CAUTION:
- Do not reuse the used injector fixing clip.
CAUTION:
- Install the component with the specified torques.
- Note that internal damage may occur if the component drops. In this case, use it after inspection.
CAUTION:
- Apply engine oil to the injector O-ring.
- Do not reuse the used injector O-ring.
CAUTION:
- Do not reuse the used bolt.
CAUTION:
- When inserting the injector, be careful not to damage the injector tip.
CAUTION:
- Do not reuse the support disc.
- Do not reuse the injector rubber washer.
- When replacing the rubber washer, the rounded edge (A) should face the cylinder installation and the angulated edge (B) should face the injector body.
CAUTION:
- Do not reuse the combustion seal.
- To install, reverse the removal procedure.