LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2019 >> G70 2.0T Advanced, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 2.0L >> Injector >> Repair Procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

  1. Release the residual pressure in fuel line.

    (Refer to Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  2. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
  3. Remove the intake manifold.

    (Refer to Engine Mechanical System - "INTAKE MANIFOLD ")

  4. Remove the delivery pipe foam (A).
    G13539419Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the cowl top cover assembly.

    (Refer to Body (Interior and Exterior) - COWL TOP COVER ")

  6. Remove the engine box cover (A).
    G13539420Courtesy of HYUNDAI MOTOR AMERICA
  7. Disconnect the front control connector (A).
  8. Remove the ground terminal nuts (B).
    G13539421Courtesy of HYUNDAI MOTOR AMERICA
  9. Remove the wiring protector (A).
    G13539422Courtesy of HYUNDAI MOTOR AMERICA
  10. Remove the high pressure fuel pipe.
    1. Remove the high pressure fuel pipe mounting bolt (A).
      G13539423Courtesy of HYUNDAI MOTOR AMERICA
    2. Remove the high pressure fuel pipe flange nut (A).
      G13539424Courtesy of HYUNDAI MOTOR AMERICA
    G13539425Courtesy of HYUNDAI MOTOR AMERICA
  11. Remove the mounting bolts (A), and then remove the delivery pipe & injector assembly from the engine.
    G13539426Courtesy of HYUNDAI MOTOR AMERICA
  12. Disconnect the injector & rail pressure sensor connector (A).
  13. Remove the injector (B) from the delivery pipe.
    G13539427Courtesy of HYUNDAI MOTOR AMERICA
    G13539428Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals