April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
Remove the water center pipe.
(Refer to Engine Mechanical System - "WATER TEMPERATURE CONTROL ASSEMBLY ")
Disconnect the connector (A), and then remove the CWT oil pressure sensor (B).

G13543351

Courtesy of HYUNDAI MOTOR AMERICA

NOTE:

When removing and installing the oil temperature sensor, use a deep socket as shown in the illustration below.

3/8" drive deep socket (24 mm) with the wall thin and the length less than 75 mm.

G13543352

Courtesy of HYUNDAI MOTOR AMERICA

[Arrangement of tools for removing oil temperature sensor]

G13543353

Courtesy of HYUNDAI MOTOR AMERICA

[Installation order for tools]

Insert a 24 mm (0.94 in.) deep socket (A) to the oil temperature sensor.

Courtesy of HYUNDAI MOTOR AMERICA
After connecting other tools as arranged in the above image, insert the tools (A) to socket.