LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2020 >> G80 3.8, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 3.8L >> Oil Pressure Sensor (OPS) >> Repair Procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the Air Cleaner Assembly.

    (Refer to Engine Mechanical System - "INTAKE AND EXHAUST SYSTEM ")

  3. Remove the Delivery Pipe And Injector.

    (Refer to Fuel Delivery System - "DELIVERY PIPE ")

  4. Disconnect the connector (A), and then remove the CVVT oil temperature sensor (B).
    G12657662Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • When removing and installing the oil temperature sensor, use a deep socket as displayed in the image below.
      • 3/8" drive deep socket (24 mm) with the thin wall and the length less than 75 mm.
        G12657663Courtesy of HYUNDAI MOTOR AMERICA

      [Arrangement Of Tools For Removing Oil Temperature Sensor] 

      G12657664Courtesy of HYUNDAI MOTOR AMERICA

      [Installation Order For Tools] 

      1. Insert a 24 mm (0.94 in.) deep socket (A) to the oil temperature sensor.
        G12657665Courtesy of HYUNDAI MOTOR AMERICA
      2. After connecting other tools as arranged in the image above, insert the tools (A) to socket.
        G12657666Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals