Repair Procedures: Installation
CAUTION:
- Install the component with the specified torques.
- Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
- Apply the sealant (LOCTITE FED546 or equivalent) to the sensor.
- Insert the sensor in the installation hole and be careful not to damage when installation.
- Install in the reverse order of removal.
Oil pressure sensor installation:
14.7 - 21.6 N.m (1.5 - 2.2 kgf.m, 10.8 - 15.9 lb-ft)