Repair Procedures: Installation

NOTE:

Assemble the oxygen sensor by matching its tag with the center of the heat protector clip, and be careful not to allow the wiring to be twisted when assembling.
Install the component to the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
DON'T use a cleaner, spray, or grease to sensing element and connector of the sensor because oil component in them may malfunction the sensor performance.
Sensor and its wiring may be damaged in case of contacting with the exhaust system (Exhaust Manifold, Catalytic Converter, and so on).