Removal And Installation
NOTE:
- Install the component to the specified torques.
- If a part is dropped, replace it with a new one and discard the dropped part as invisible damage may be caused.
- Apply the engine oil to the O-ring.
- Insert the sensor in the installation hole and be careful not to damage it.
- Be careful not to damage the sensor housing and the connector.
- Be careful not to damage the O-ring.
- Switch "OFF" the ignition and disconnect the battery negative (-) terminal.
- Remove the Engine Cover.
(Refer to Engine Mechanical System - "ENGINE COVER ")
- Disconnect the camshaft position sensor connector (A).
- Remove the installation bolt (B), and then remove the crankshaft position sensor.
Tightening torque:
9.8 - 11.7 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.6 lb-ft)
[Bank 1/Intake]
[Bank 1/Exhaust]
- Install in the reverse order of removal.