Removal & Installation
NOTE:
- Install the component to the specified torques.
- Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
- Apply sealant to thread when refitting.
Specification : TB2403
- Switch "OFF" the ignition and disconnect the battery negative (-) terminal.
- Remove the Alternator.
(Refer to Engine Electrical System - "ALTERNATOR ")
- After disconnecting the oil pressure & oil temperature sensor connector (A), remove the oil pressure & oil temperature sensor (B).
Tightening torque:
34.3 - 38.2 N.m (3.5 - 3.9 kgf.m, 25.3 - 28.2 lb-ft)
- Install in the reverse order of removal.