LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2024 >> GV70 2.5T Advanced >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> AWD Control System >> AWD Ecu >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

AWD Ecu: Removal

CAUTION: In case of replacing the controller (ECU) and transfer case due to changing characteristics of the frictional materials inside the transfer case, it is necessary to check and enter the calibration data.
Refer to AWD ECU - "ADJUSTMENT ")
  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the floor console.

    (Refer to Body (Interior and Exterior) - "FLOOR CONSOLE ASSEMBLY ")

  3. Remove the front seat assembly. [RH]

    (Refer to Body (Interior and Exterior) - "FRONT SEAT ASSEMBLY ")

  4. Remove the cowl side trim. [RH]

    (Refer to Body (Interior and Exterior) - "COWL SIDE TRIM ")

  5. Remove the center pillar lower trim.

    (Refer to Body (Interior and Exterior) - "CENTER PILLAR TRIM ")

  6. Remove the rear duct (A).
    G16847494Courtesy of HYUNDAI MOTOR AMERICA
  7. Pull the carpet (A) and then disconnect the AWD ECU connector (B).
    G16847495Courtesy of HYUNDAI MOTOR AMERICA
  8. Loosen the nuts and then removing the AWD ECU (A).
    G16847496Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals