Lock-Up Relay (Tracker A/T)
- Turn ignition off. Locate lock-up relay at right rear corner of engine compartment, in front of battery. Disconnect lock-up relay connector. Using an ohmmeter, check continuity between Light Green/Red wire terminal of relay and White/Yellow wire terminal of relay. If continuity does not exist, replace relay.
- Apply battery voltage to Light Green/Red wire terminal of relay. Apply ground to White/Yellow wire terminal of relay. Using an ohmmeter, check continuity between White and White/Red wire terminals of relay. If continuity does not exist, replace relay. Continuity should only exist while relay is energized.