Chart A-3, Cranks But Won't Run: Notes

Electronic Spark Timing (EST) is controlled by ECM. Ignition module sends a reference signal on Yellow/Red wire to ECM when engine is cranking. With engine speed less than 400 RPM, ignition module will control ignition timing. When engine speed is greater than 400 RPM, ECM applies 5 volts on by-pass line (Yellow/Green wire) to switch timing control to ECM (EST mode). In EST mode, ECM controls ignition timing.

1. If CHECK ENGINE light is on with ignition on, ECM is receiving voltage. ECM is located under left side of instrument panel, left of steering column, and contains a 24-pin and 32-pin connectors. If TPS voltage exceeds 2.5 volts, engine may be in clear flood mode, resulting in starting problems. Engine will not start without reference pulses; Scan tool should indicate engine speed during cranking.
2. If engine speed is indicated during cranking, ignition module is receiving a crank signal; however, if spark is not present during cranking, ignition module is not triggering ignition coil, or secondary ignition problem exists.
3. Test light should flash, indicating ECM is controlling fuel injectors.
4. This determines whether ignition module is not generating reference pulse, wiring is defective, or ECM is defective. When connecting and removing test light with battery voltage on Yellow/Red wire, a reference pulse should be generated. If engine speed is indicated, ECM and wiring are okay.
5. This checks for ignition voltage at fuel injector wiring harness. Disconnect wiring harness before probing Red/Green wire. Reinstall wiring harness connector after checking for voltage.
6. This checks for open in Blue/White or Blue/Yellow wire from connector to ECM. Ensure fuel injector wiring harness is installed.