Ignition Timing

Start and warm engine to normal operating temperature. Turn engine off and leave ignition on for 5 seconds, then state engine again. Turn engine and all accessories off. Attach timing light to No. 1 spark plug wire.
Remove cap from diagnostic connector, located in engine compartment, near fusible link box by the battery. Connect a jumper wire between terminals "C" (Black wire) and "D" (Blue/Red wire) of diagnostic connector.

Start engine and check timing mark alignment on crankshaft pulley with timing marks on timing belt cover. Ignition timing and idle speed must be within specification. See IGNITION TIMING SPECIFICATIONS table.

IGNITION TIMING SPECIFICATIONS (Degrees BTDC@RPM) ⁽¹⁾

Application

Man. Trans.

Auto. Trans.

Tracker

⁽²⁾ 8@800

⁽¹⁾	If specification differs from emission label, use specification listed on emission label.

⁽²⁾	Specification listed with jumper wire installed between terminals "C" (Black wire) and "D" (Blue/Red wire) of diagnostic connector, located near fusible link box by the battery.

If ignition timing is not within specification, loosen distributor hold-down flange bolt and rotate distributor to obtain correct ignition timing. Tighten distributor hold-down flange bolt to 11 ft. lbs. (15 N.m). Recheck ignition timing.
Turn engine off. Remove jumper wire and install cap on diagnostic connector. Remove timing light.