Removal & Installation
- Oxygen sensor is mounted in exhaust manifold or exhaust pipe, below exhaust header. Sensor is equipped with a permanent pigtail which must be protected from damage when removing sensor. Ensure sensor is free of contaminants, but avoid using cleaning solvents of any type.
- Sensor may be difficult to remove when engine temperature is less than 120°F (49°C). If O2S is difficult to remove, use rust penetrant to avoid possible damage to exhaust manifold threads. Discard O2S sensor if contaminated.
- Always use anti-seize compound on threads before installing NEW sensor. New sensor comes pre-coated with anti-seize. DO NOT remove anti-seize from sensor. Tighten O2S to 30 ft. lbs. (41 N.m).