Pressure Tank Bleeding
- Clean master cylinder cap and surrounding area, and remove cap. Add brake fluid, if needed. Connect pressure tank to master cylinder following manufacturers instructions.
- Bleed hydraulic modulator. Attach clear vinyl hose to rear bleed screw on hydraulic modulator. Place other end of hose in clean, transparent container. Partially fill container with clean brake fluid until end of hose is submerged in fluid.
- Slowly open bleed screw 1/2-3/4 turn. When fluid flowing into container is clear and bubble free, close bleed screw securely. Repeat procedure to bleed hydraulic modulator at front bleed screw. When fluid flows from both hydraulic modulator bleed screws without air bubbles, bleed wheels.
- Attach vinyl hose to first bleed screw to be serviced. See BRAKE LINE BLEEDING SEQUENCE table. Place other end of hose in clean, transparent container. Partially fill container with clean brake fluid until end of hose is submerged in fluid.
- Open bleed screw, noting fluid flow. When fluid flowing into container is clear and bubble free, close bleed screw securely. Finish bleeding system, in the same manner, using appropriate sequence. Close release valve, and remove pressure tank from master cylinder. Check master cylinder reservoir fluid level.
BRAKE LINE BLEEDING SEQUENCE
| Application | Sequence |
|---|---|
| Prizm | RR, LR, RF, LF |