LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Geo >> 1995 >> Prizm Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests - 1.6L >> Computerized Engine Controls >> Engine Sensors & Switches >> Throttle Position (TP) Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Throttle Position (TP) Sensor

  1. A malfunction in the throttle position sensor circuit will set DTC 41. For testing and adjusting procedures, see THROTTLE POSITION (TP) SENSOR in ADJUSTMENTS - 1.6L article. Use the following procedure to diagnose TP sensor.
  2. Using ohmmeter, measure resistance or continuity of throttle position sensor between designated terminals with selected feeler gauge thickness between throttle lever and stop screw. See Fig 1 . Adjust or replace TP sensor if resistance is not within specification. See THROTTLE POSITION (TP) SENSOR RESISTANCE  table.
Fig 1: Identifying TP Sensor Terminals (1.6L Prizm)
G93F78118Courtesy of GENERAL MOTORS CORP.
THROTTLE POSITION (TP) SENSOR RESISTANCE

Application Ohms
Between Terminals E2 & IDL (1) 0-2300
Between Terminals E2 & IDL (2) Infinity
Between Terminals E2 & VC 3000-8500
Between Terminals E2 & VTA (3) 200-6000
Between Terminals E2 & VTA (4) 3300-10,000
(1) With .016" (.40 mm) feeler gauge installed between throttle stop screw and lever.
(2) With .035" (.89 mm) feeler gauge installed between throttle stop screw and lever.
(3) With zero clearance between throttle stop screw and lever.
(4) Throttle valve at fully open position.
scientia non olet · About LEMON Manuals