Fuel System Pressure Release
CAUTION:
DO NOT perform this procedure when engine is hot. Doing so may have an adverse effect on catalytic convertor.
- Place transmission in Neutral (M/T) or Park (A/T). Set parking brake and block drive wheels. Disconnect fuel pump relay. See FUEL PUMP RELAY LOCATION table.
- Remove fuel filler cap to release fuel vapor pressure in fuel tank. Reinstall fuel filler cap. Start engine and run until engine dies. After engine dies, crank engine 2-3 times for about 3 seconds to dissipate fuel pressure in lines. To restore normal operation, reinstall fuel pump relay.
FUEL PUMP RELAY LOCATION
| Application | Location |
|---|---|
| Tracker | Passenger Compartment, Behind Left Side Of Glove Box |