Auto. Trans. Models
- Jack up and support the front of vehicle. Push the voltmeter or test light positive probe into the Yellow/Black wire terminal at the control unit connector.
- Connect the negative probe to ground. Start engine. Place vehicle in second position (gear selector in 2 position) and accelerate slowly. Battery voltage should be as shown in table.SPEED SENSOR VOLTAGE CHECK
Speed Voltage Below 11 MPH Yes Above 16 MPH No - If voltmeter readings do not correspond to above MPH ranges, install a new speed sensor and retest. If there was no voltage during step 2), check for bad electrical connection, fuse or faulty speed sensor. Replace or repair as necessary and retest.