LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 1987 >> Prelude Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> PGM-FI Electronic Control System >> Testing >> Code 3, Map Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 3, Map Sensor

  1. Turn ignition off. Remove clock fuse in the under-hood relay box for 10 seconds to reset ECU. Start engine and observe PGM-FI warning light. If light is off, problem is intermittent. Test drive and check again.
  2. If light is on, turn ignition off. Connect test harness between MAP sensor and sensor harness. Turn ignition on. Measure voltage between Red (pos.) and Green (neg.) terminals. If reading is about 5 volts, go to step 4). If not, measure voltage between Red (pos.) terminal and ground. If voltage is still not 5 volts, go to step 3). If voltage is about 5 volts, repair open in Blue/White wire between ECU terminal C14 and MAP sensor.
  3. Turn ignition off. Connect system checker harness between ECU and ECU harness. Measure voltage between terminal C15 (pos.) and C14 (neg.) with ignition on. If voltage reading is about 5 volts, repair open Red/White wire between ECU terminal C15 and MAP sensor. If voltage is not about 5 volts, substitute a known good ECU. If condition is rectified, replace original ECU.
  4. Measure voltage between White (pos.) and Green (neg.) terminals. If reading is not about 3 volts, replace MAP sensor or repair short in White/Blue wire between ECU terminal C11 and MAP sensor.
  5. If measured voltage is about 3 volts, turn ignition off. Connect system checker harness between ECU and ECU connectors. Turn ignition on. Measure voltage between terminals C11 (pos.) and C14 (neg.). If there is not about 3 volts present, repair open White/Blue wire between ECU terminal C11 and MAP sensor.
  6. If there are about 3 volts present, substitute a known good ECU. If condition is rectified, replace original ECU.
scientia non olet · About LEMON Manuals